Home / Pulse oximeters — handheld devices with a re
Pulse oximeters — handheld devices with a real sensor range behind them
SpO2 range35–99%
Pulse rate30–245 bpm
DisplaySpO2 · PR · bar graph
SensorsAdult → neonatal
A handheld oximeter is only as useful as the sensors that fit it. The device line here is built around that fact: handheld pulse oximeters (SpO2 measuring range 35–99%, pulse rate 30–245 bpm, with bar-graph display) supplied with the same sensor ecosystem as the monitor range — finger-clip, silicone soft-tip, wrap and disposable sensors for adult through neonatal patients — so one device can move from ward spot-checks to neonatal screening without a second accessory supply chain.
The catalogue also carries PPG-based fingertip sensing product references (a 400 Hz-sampling SpO2 module line) for device integrators, alongside the clinical handhelds. Every device pattern is supplied as a system: device, sensor, and the replacement sensors that keep it in service.
Choosing a handheld oximeter configuration
Decide by patient and by workflow. Spot-check wards and clinics run a finger-clip sensor on an adult default; paediatric and neonatal work needs the wrap and soft sensors, which is where a shared sensor catalogue matters — the neonatal wrap that fits the monitor line has a handheld counterpart. Battery format, display orientation and alarm needs differ by department; state the use case and the configuration (device + sensor set) is quoted as one line.
- Handheld oximeters with SpO2, pulse rate and bar-graph display
- Matched sensors: clip, soft-tip, wrap, disposable
- Fingertip oximetry for screening and spot checks
Devices within a cleared product family
Oximetry is the founding product family of this factory — its adult SpO2 sensors are the subject of its first FDA 510(k), K083010, and the Med-Link pulse oximeter device is cleared under K202743 — and the device line is supported with the same twelve-month standard warranty pattern as the sensor range (confirm the term for your configuration in the quotation).
Representative products from the current catalogue
| Product (official store listing) | Key specifications |
|---|---|
| 400Hz Raw PPG Data Pulse Oximeter with Bluetooth & USB, for Biomedical Research and Algorithm Development | SpO₂ Measurement Range: 35% – 99%；Pulse Rate Range: 30 – 245 bpm；PPG Sampling Rate: 400 Hz；Communication Interface: USB Type-C；Display: OLED；Power Supply: 2 × AAA Batteries |
| 400Hz Raw PPG Pulse Oximeter, USB Developer Device for Biomedical Algorithm Research | SpO₂ Measurement Range: 35% – 99%；Pulse Rate Range: 30 – 245 bpm；PPG Sampling Rate: 400 Hz；Communication Interface: USB Type-C；Display: OLED；Power Supply: 2 × AAA Batteries |
| Adult Finger Clip SpO2 Sensors for Medlinket AM801 Temperature & Pulse Oximeter | Medlinket: S0162B-S；Category: SpO2；Monitor End Connector: Male, USB 12PIN；Total Cable Length: 2.6ft (0.8m)；Cable Material: TPU Jacket；Packaging Unit: 1；Weight: 0.1lb；SpO2 Tech: Digital Tech；Patient End Connector: Adult Finger Clip；Patient S |
| Adult Silicone Soft SpO2 Sensors | Medlinket: S0010D-S；Category: SpO2；Monitor End Connector: Male, USB 12PIN；Total Cable Length: 2.9ft (0.9m)；Cable Material: TPU Jacket；Packaging Unit: 1；Weight: 0.1lb；SpO2 Tech: Digital Tech；Patient End Connector: Adult Silicone Soft；Patient |
| Adult Silicone Soft SpO2 Sensors for Medlinket AM801 Temperature & Pulse Oximeter | Medlinket: S0010D-S；Category: SpO2；Monitor End Connector: Male, USB 12PIN；Total Cable Length: 0.7ft (0.2m)；Cable Material: TPU Jacket；Packaging Unit: 1；Weight: 0.1lb；SpO2 Tech: Digital Tech；Patient End Connector: Adult Silicone Soft；Patient |
Questions & answers
Which sensors fit the handheld oximeters?
The handheld line uses the same sensor families as the monitor range — clip, soft-tip, wrap and disposable — matched to the device connector. The configuration is confirmed in the quotation.
Can one device serve adult and neonatal patients?
Yes, with the right sensors: swap the adult clip for a neonatal wrap sensor. Sensor choice, not the device, sets the patient range.
Is a fingertip oximeter suitable for continuous monitoring?
Fingertip devices suit spot checks and screening. For continuous monitoring, use a handheld or monitor configuration with an appropriate sensor and alarms.
See also: SpO2 sensors · What is SpO2? · Configure a device + sensor set